Procedures involved in the production of synthetic slag - Born2Invest
  • .
    Mining

    Procedures involved in the production of synthetic slag

  • Synthetic slag could be formed at an atmospheric temperature which is normally humid.

    In the plant of steel and iron blast furnace, slag is produced from a gangue material of iron ore and ash of the metallurgical coke, which is used for reducing the material and then it is further used to control the chemistry of the slag.

    It helps in removing all the impurities from the raw material and helps to protect the furnace from the lining and excessive of wear and tear. When you come across such situation whatever you get in return is a synthetic slag. When any iron and steel plant focus on making slag they include quicklime and magnetite for the protection of re-factory.

    While making slag, alumina and silica are neutralized completely from the ore and it helps in removing phosphorus and sulfur during the treatment of metallic treatment in the liquid form. Slag conditioner plays a vital role when we are into the production of synthetic slag.

    The synthetic slag consists of several calcium aluminates which occur in the entire system and from which very few are only stable. The calcium aluminates are some specific kind of salt made from calcium hydroxide and aluminic acid. It is a very clear fact that many useful minerals are obtained when you heat the calcium oxide and aluminium oxide which is also known as bauxite in a very high temperature that of 400-1600 degree Celsius.

    Usually, the calcium aluminate for the synthetic slag is made from some selected material of aluminum and calcium. It I blended in it, in a very perfect and proper position, then it is ground to powder, then it is pelletized after passing through a churning process right after this it is melted or sintered in a kiln.

    SEE ALSO  Global Feldspar Production to Grow 4 Percent Annually Through 2017

    List of some minerals used in a synthetic slag:

    – C12A7

    – CA

    – C3A

    – CA2

    Synthetic slag could be formed at an atmospheric temperature which is normally humid. This is an ideal temperature for its formation.

    List of some chemicals included in the formation of synthetic slag:

    Tricalcium Aluminate

    It is one of the basic forms of calcium aluminate; it is one of the most important phases of mineral all the way from Portland.

    Dodecalciumhept-the aluminate

    Its properties and composition have always been the subject of being debated as there is lots of variation in the composition which may arise at the time of high temperature.

    Monocalcium aluminate

    This mineral is formed when the appropriate proportion of aluminium oxide and calcium carbonate are put together and heated till the mixture of the same melts really well. It melts really well at 1390 degree Celsius. It is also a series of calcium aluminates.

    Synthetic slag production needs lots of systematic proportion of chemicals in the right temperature. Even if there is a slight variation in the temperature, the whole chemical process may turn out to be a mess. Many chemicals are fused in to get the best out of it. Slag conditioner does functions very effectively to maintain the consistency of the output of the amalgamation of the chemicals.

    DISCLAIMER: This article expresses my own ideas and opinions. Any information I have shared are from sources that I believe to be reliable and accurate. I did not receive any financial compensation in writing this post, nor do I own any shares in any company I’ve mentioned. I encourage any reader to do their own diligent research first before making any investment decisions.

    Featured Image by Knud Winckelmann and Nationalmuseet via WikimediaCommons (CC-BY-SA-3)

    SEE ALSO  The Danger in Shipping Nickel Ore by Sea
    Click to comment

    Leave a Reply

    Your email address will not be published. Required fields are marked *

    To Top